The installation method of the CNC turning


Lifting and transportation of the CNC turning service
The special lifting tools provided by the manufacturer shall be used for the lifting and positioning of the machine tool, and other methods are not allowed. Special lifting tools are not required. Steel wire rope shall be used to lift and put in place according to the parts specified in the manual.

Foundation and location of the CNC turning service
The machine tool shall be installed on a firm foundation, and the position shall be far away from the vibration source; Avoid sunlight and heat radiation; Place in a dry place to avoid the influence of humidity and airflow. If there is vibration source near the machine tool, anti vibration ditch must be set around the foundation.

Installation of machine tool of the CNC turning service
When the machine tool is placed on the foundation, it shall be leveled in a free state, and then the anchor bolts shall be locked evenly. For ordinary machine tools, the reading of level gauge shall not exceed 0.04/1000mm, and for high-precision machine tools, the reading of level gauge shall not exceed 0.02/1000mm. When measuring the installation accuracy, it should be carried out at a constant temperature, and the measuring tool should be used after a period of constant temperature time. When installing the machine tool, try to avoid the installation method of forced deformation of the machine tool. During the installation of the machine tool, some parts of the machine tool should not be removed randomly. The removal of parts may lead to the redistribution of internal stress in the machine tool, thus affecting the accuracy of the machine tool.
We use cookies to offer you a better browsing experience, analyze site traffic and personalize content. By using this site, you agree to our use of cookies. Privacy Policy